Wuxi Liguo Machinery Manufacturing Co., LTD

Vertical and horizontal tube and rod straightening machine, Coil straightening cutting machine!

Home > Exhibition > Content
The structure of automatic straightening and cutting machine and its operating principle
- Aug 28, 2018 -

Automatic straightening and cutting machine It is one of the straightening equipment and one of the steel processing machines. It is mainly used to straighten and cut the steel bars with a diameter of 14 mm or less. The cutting length can be customized according to customer requirements. The straightening and cutting machine of the automatic straightening and cutting machine has stainless steel wire, aluminum wire, cold drawn wire, plastic coated steel wire, etc., not only that, but also the processing effect is very satisfactory, the incision is uniform, the error is small, and the performance is good.


The automatic straightening and cutting machine is mainly composed of a cutting mechanism, an eccentric mechanism, a power mechanism, and a wire dropping mechanism. When the automatic straightening and cutting machine is operated, the motor accelerates through the belt drive, so that the straightening cylinder rotates at a high speed, the reinforcing steel passing through the straightening cylinder is straightened, and the scale of the steel surface is removed by the straightening mold.


At the same time, the motor passes through another pair of reduction belt drive and gear reduction box. On the one hand, it drives two conveying pressure rollers, and the traction steel rod moves forward, and on the other hand drives the crank wheel to move the hammer head up and down. When the automatic straightening and cutting machine adjusts the steel bar to a predetermined length, the hammer hammer hits the tool holder and cuts the steel bar. When the cut steel bar falls into the receiving frame, the knife table returns to the original position due to the spring action, completing a cycle. .


In the work, the automatic straightening and cutting machine should adjust the pressure according to the diameter and rigidity of the processed wire to obtain the best straightening effect and production efficiency.